Aviall Product Catalog And Source Book Page 133 Hardware, Hose & Fittings

STRATOFLEX HOSE & FITTINGS aviall.com aviall ability 133 191 PTFE HOSE & FITTINGS Ordering Information for Standard Items 1. Hose assembly: Straight-to-straight or straight-to-single elbow example: 191001-8 CR-0185 Basic hose assembly number Assembly length in inches. Last digit is eighths of an inch. Size ( 1 /2" O.D. tube size) in 1 /16" See material note below Double elbow example: 191060 E 0185 C 180 Basic hose assembly number Size ( 1 /2" O.D. tube size) in 1 /16" Size code for double elbow hose assemblies Dash Size -4 -6 -8 -10 -12 SF Code Letter B D E F G Material: Unless otherwise noted, conforms to applicable specifications. C or CR Non-brazed/welded parts - SAE 30304 (AMS5639) or SAE 30304L (AMS5647) Brazed/welded parts - SAE 30321 (AMS5570 or AMS5645) Other materials: titanium, Inconel, etc, available. CL Same as CR except lockwire holes in nut Length measurement: length is measured along hose centerline from end of nipple to end of nipple Note: For additional information on special materials or accessories, contact Stratoflex. Note: Unless otherwise noted, dimensions shown herein are nominal and are subject to change without notice. Contact Stratoflex Engineering for current data. 2. Identification bands: An example of Identification bands used when required for Hose Assemblies conforming to TSO C75Type II-B-S/P follows: 3. Standard length tolerances are: Under 18 in............. 0.125 in. 18 in.to 36 in.......... 0.250 in. 36 in.to 50 in......... 0.500 in. Over 50 in...................... 1% Twist angle (180 - see page 65) See material note below Assembly length in inches. Last digit is eighths of an inch.

Previous Page
Next Page