Aviall Product Catalog And Source Book Page 2399 Tools & Test Equipment

TWIST DRILLS CLEVELAND TWIST DRILL DRILLS aviall ability aviall.com 2399 Aircraft screw machine length drill. AIA STANDARDS, TYPE C. Designed for use in machines and portable drilling in hard and tough sheet metal alloys of the heat resistant, stainless and titanium types. Part No. Description Comments 2130-51 0.0670" diameter drill 2130-40 0.0980" diameter drill 2130-1-8 0.1250" diameter drill 2130-30 0.1285" diameter drill For use with -4 nominal size CherryLock and CherryMAX rivets 2130-9-64 0.1406" diameter drill 2130-27 0.1440" diameter drill For use with -4 oversize CherryLock and CherryMAX rivets 2130-5-32 0.1562" diameter drill 2130-21 0.1590" diameter drill 2130-20 0.1610" diameter drill For use with -5 nominal size CherryLock and CherryMAX rivets 2130-16 0.1770" diameter drill For use with -5 oversize CherryLock and CherryMAX rivets 2130-11-64 0.1719" diameter drill 2130-3-16 0.1875" diameter drill 2130-10 0.1935" diameter drill For use with -6 nominal size CherryLock and CherryMAX rivets 2130-13-64 0.2031" diameter drill 2130-5 0.2055" diameter drill For use with -6 oversize CherryLock and CherryMAX rivets 2130-15-64 0.2344" diameter drill 2130-1/4 0.2500" diameter drill 2130F 0.2570" diameter drill For use with -8 nominal size CherryLock and CherryMAX rivets 2130-17-64 0.2656" diameter drill 2130I 0.2720" diameter drill For use with -8 oversize CherryLock and CherryMAX rivets Notes: 1. CherryMAX oversize rivets are 1/64" diameter larger than nominal size rivets. Please refer to Textron Fastening Systems - Aerospace manuals for additional information about rivet selection. 2. Normally, nominal size rivets are used for new construction and oversize rivets are used for repairs, where rivet holes may have elongated over time. 3. Also review manual AC43-13 Acceptable Methods of Aircraft Repair (ASAAC43-13B) for additional information. 4. For special Plexiglass drill bits, see the accessories section in LP AeroPlastic on page 1007 Aircraft extension drills. AIA-NAS-907 STANDARDS DATED 1973. Used principally for the drilling of holes in inaccessible places which cannot be reached with regular length drills. These tools are all furnished with jobbers drill flute length. Part No. Description Length 3917-6 118 split point bright finish 6" 3947-6 135 split point surface treated 6" 3917-12 118 split point bright finish 12" 3947-12 135 split point surface treated 12" 3917-6 3947-6 3947-12 3917-12 See next page for fractional equivalent dash no.

Previous Page
Next Page